Related pages:
# | Action | Sequence of Commands on the Remote Control | Comments | |
---|---|---|---|---|
A | Factory Reset | 1 | Press “Power on” | TV must be running. TV must not be in Standby Mode |
2 | Press “Exit” for 20 seconds | Message “Resets all settings to default values”, with options “ok” and “cancel” | ||
3 | Select “ok” by pressing ”<” or ”>” of the selection wheel | Warning, It might be risky to do so with a TV set which might be specially prepared for a commercial environment ( hotel, shop,.. ) | ||
4 | Press “Return” | |||
5 | Press “Power on” | Enter Standby Mode | ||
B | Enter the Service Menu | 1 | Standby Mode | |
2 | Press “info” | |||
3 | Press “menu” | |||
4 | Press “mute” | |||
5 | Press “Power on” | You are now in the Service Menu | ||
6 | Edit Service Menu settings. In many cases, changes have to be acknowledged by pressing “Return” after the change | |||
7 | Press “Power on” | Leave Service Menu | ||
C | Disable/enable Hotel Option | 1 | Do a “Factory Reset” | See (A) |
2 | Enter the Service Menu | See (B) | ||
You might do a Factory Reset from here | ||||
3 | Select “Control” | |||
4 | Select “Hotel Option” | |||
5 | Press ”<” or ”>” of the selector wheel to select an option | Select Hotel Option “on” or “off” | ||
6 | Press “Return” | Important: Just by pressing “Return”, the change is acknowledged | ||
7 | Press “Power on” | Enter Standby Mode | ||
D | Set TV channels | 1 | Factory Reset and disable Hotel Option | See (C) |
3 | Select “Plug & Play” | Message “If you enter PIN, 'Plug & Play' will be started' | ||
4 | Enter PIN | The PIN after Factory Rest is 0, 0, 0, 0 | ||
5 | Press “Enter” | |||
6 | Press “Power on” | Enter Standby Mode | ||
7 | if you are editing a public TV set like in a hotel: Be shure to enable Hotel Option if it was originally enabled ![]() |
|||